spi-imx8lpspi
Driver for NXP i.MX8 low-power SPI controllers
Syntax:
spi-imx8lpspi [-c config_file] [-v]
Runs on:
QNX OS
Options:
These are the options available for this driver.
- -c config_file
- Path to the SPI configuration file (default: /etc/system/config/spi/spi.conf)
- -v
- Increase verbosity. This overrides the "verbose" value in the configuration file.
Driver-specific options You set these options in the configuration file in the bus section using the bs parameter.
- dma
- Enable DMA transfer (disabled by default).
- dbt=num
- Delay between transfers. In terms of half SPI shift clock. (Default is 0.)
- pcssck==num
- Delay from the PCS assertion to the first SCK edge. In terms of half SPI shift clock. (Default is 0.)
- sckpcs==num
- Delay from the last SCK edge to the PCS negation. In terms of half SPI shift clock. (Default is 0.)
- pincfg==num
- Pin configuration.
- 0—(default) use SDI for input data and SDO for output data.
- 1—use SDI for both input and output data.
- 2—use SDO for both input and output data.
- 3—use SDO for input data and SDI for output data.
- smmu=[ on | off | 1 | 0 ]
- Turn on (1) or off (0; default) the use of local I/O MMU protection services.Use only with dma.
Description:
Driver for NXP i.MX8 Low Power SPI controllers
Example:
Start SPI driver :
spi-imx8lpspi -c /etc/custom/spi.conf
Page updated: