About This BSP
QNX Board Support Packages8.0BSP User's GuideNXP S32G399 RDB3NXPNXPARM
These notes list what's included in the BSP, and identify the host OSs and boards it supports.
What's in this BSP
This BSP contains the
following components:
For the status of a driver, see the release notes for this BSP.
| Component | Format | Comments |
|---|---|---|
| Startup | Binary and source | |
| Serial driver | Binary and source | |
| I2C driver | Binary and source | |
| SD/MMC driver | Binary and source | |
| Network driver | Binary only | |
| Watchdog | Binary and source | |
| SPI driver | Binary and source | |
| CAN driver | Binary and source | |
| EDMA library | Binary and source | |
| QSPI NOR flash driver | Binary and source | |
| USB Host Driver | Binary Only | |
| PCI HW module driver | Binary Only | |
| gpio-siul2 | Binary and source |
Supported OSs
To install and use
this BSP, you must have installed the QNX SDP 8.0
on a Linux or Windows host. This BSP supports the following target OS:
- QNX OS 8.0
Supported boards
In the QNX Software Center, see the release notes for this BSP for
the list of supported boards using these steps:
- On the Available or Installed tab, navigate to Board Support Packages BSP, right-click Name_of_your_BSP, and then select Properties.
- In the Properties for BSP_name window, on the General Information pane, click the link beside Release Notes.
Interrupt table for this board
The interrupt vector table can be found in the buildfile located at images/s32g399-rdb3.build in your BSP. This interrupt table is a useful reference when you want to write custom resource managers or customize the BSP.
Known issues
For the list of known issues, see the release notes for this BSP.
Page updated: