Before you begin

Before you begin working with this BSP you should become familiar with the resources available to you when building QNX embedded systems.

Essential information

Before you install your BSP, review the following documentation:

  • Information about your board's hardware and firmware is provided by the board vendor. For documentation for Texas Instruments Jacinto 7 J742S2 Evaluation Module, please request Processor SDK J742S2 access from Texas Instruments.
  • Building Embedded Systems. This guide contains general information about working with BSPs from QNX Software Systems that's common to all BSPs and is available from the QNX Software Development Platform 8.0 documentation.

Required software

To work with this BSP, you require the following:

  • BSP ZIP file for the board.
  • QNX Software Development Platform 8.0 installed on a Linux or Windows host system.
  • Virtual COM Port (VCP) Driver. This driver must be installed on your host system that connects to the board. To get the driver and read more information about it, see the Future Technology Devices International Ltd. (FTDI) website at http://www.ftdichip.com/FTDrivers.htm.
  • A terminal emulation program (Qtalk, Hyperterminal, PuTTy, etc.) to connect to the board for debugging. Alternatively, you can use a ssh session from the QNX Momentics IDE with username qnxuser and password qnxuser.
    Warning:
    QNX does not recommend hardcoded passwords on systems and that the BSP is configured like this for developer purposes only. For more information, see Systems without passwords in the QNX OS System Security Guide in the QNX SDP 8.0 documentation.
Page updated: