Home
QNX SDP 8.0 BSP Documentation
The board support package (BSP) documentation includes user guides that describe how to work with the BSPs provided for the QNX Software Development Platform (SDP) 8.0, and release notes that describe the supported features and hardware as well as any known issues for each BSP.
Broadcom
Raspberry Pi 4 BCM2711
User's Guide
Installation Notes
These installation notes describe how to build, work with, and run this BSP.
Set up the hardware
System Layout
The following is the memory layout required for the Xilinx KD240.

QNX SDP 8.0 BSP Documentation
The board support package (BSP) documentation includes user guides that describe how to work with the BSPs provided for the QNX Software Development Platform (SDP) 8.0, and release notes that describe the supported features and hardware as well as any known issues for each BSP.
- AMD
- Broadcom
  - Raspberry Pi 4 BCM2711
    - Release Notes
    - User's Guide
      - Before You Begin
        Before you begin working with this BSP, you should become familiar with the resources available to you.
      - About This BSP
        These notes list what's included in the BSP, and identify the host OSs and boards it supports.
      - Installation Notes
        These installation notes describe how to build, work with, and run this BSP.
        Download and set up the BSP
        You can download Board Support Packages (BSPs) using the QNX Software Center.
        Set up the hardware
        System Layout
        The following is the memory layout required for the Xilinx KD240.
        Prepare a bootable microSD card
        You can prepare a bootable microSD card on a Linux, or Windows host system. We recommend that you use Class 10 (or UHS-1) microSD cards.
        Prepare a bootable microSD card using Raspberry Pi Imager
        You can use Raspberry Pi Imager to install Pi OS to a bootable microSD card on a Linux or Windows host system. We recommend that you use Class 10 (or UHS-1) microSD cards.
        Transfer the image
        After you prepare a bootable microSD card, you're ready to transfer the image to it and change the system configuration file config.txt to boot QNX IFS image.
        Boot the board
        After you transfer the image to an microSD, you can use it to boot your board.
      - Build the BSP
        You can use the QNX Momentics IDE or the commandline on Linux or Windows to build an image.
      - Driver Commands
        The tables below provide a summary of driver commands for the Xilinx KD240.
      - BSP-specific Drivers and Utilities
- Intel
- NXP
- Texas Instruments
Typographical Conventions, Support, and Licensing
This section describes the typographical conventions used throughout the documentation, explains how to obtain technical support, and provides some information about licensing.

System Layout

The following is the memory layout required for the Raspberry Pi 4 board.

The table below shows the memory layout for the BSP image:


Item	Start	End
OS image location	`0x80000`

Page updated: September 26, 2025