Home
QNX SDP 8.0 BSP Documentation
The board support package (BSP) documentation includes user guides that describe how to work with the BSPs provided for the QNX Software Development Platform (SDP) 8.0, and release notes that describe the supported features and hardware as well as any known issues for each BSP.
Broadcom
Raspberry Pi 4 BCM2711
User's Guide
BSP-specific Drivers and Utilities
devs-genet.so
Driver for the Raspberry Pi GENET ETHERNET

QNX SDP 8.0 BSP Documentation
The board support package (BSP) documentation includes user guides that describe how to work with the BSPs provided for the QNX Software Development Platform (SDP) 8.0, and release notes that describe the supported features and hardware as well as any known issues for each BSP.
- AMD
- Broadcom
  - Raspberry Pi 4 BCM2711
    - Release Notes
    - User's Guide
      - Before You Begin
        Before you begin working with this BSP, you should become familiar with the resources available to you.
      - About This BSP
        These notes list what's included in the BSP, and identify the host OSs and boards it supports.
      - Installation Notes
        These installation notes describe how to build, work with, and run this BSP.
      - Build the BSP
        You can use the QNX Momentics IDE or the commandline on Linux or Windows to build an image.
      - Driver Commands
        The tables below provide a summary of driver commands for the Xilinx KD240.
      - BSP-specific Drivers and Utilities
        devc-serminiuart
        Serial driver for the mini UART on the Xilinx KD240.
        devs-genet.so
        Driver for the Raspberry Pi GENET ETHERNET
        devu-hcd-bcm2711-xhci.so
        Driver for Extensible Host Controller Interface (XHCI) USB controllers on Xilinx KD240 variants
        i2c-bcm2711
        Driver for inter-integrated circuits on the Xilinx Zynq UltraScale+ MPSoC KD240 Evaluation Kit.
        spi-bcm2711
        Enhanced Serial Peripheral Interface (SPI)
        gpio-bcm2711
        GPIO utility for BCM2711 SOC
        mbox-bcm2711
        Mailbox utility for BCM2711 SOC
- Intel
- NXP
- Texas Instruments
Typographical Conventions, Support, and Licensing
This section describes the typographical conventions used throughout the documentation, explains how to obtain technical support, and provides some information about licensing.

devs-genet.so

Driver for the Raspberry Pi GENET ETHERNET

Syntax:

io-soci -m fdt -m phy -d genet [option[,option ...]]

mount -T io-sock [-o option[,option...]] fdt
mount -T io-sock [-o option[,option...]] phy
mount -T io-sock [-o option[,option...]] genet

Runs on:

QNX OS

Options:

Use commas, not spaces, to separate the options.

prefix=prefix: Specifies the instance of io-sock that mounts this driver. You specify the prefix that creates an alternative stack when you start io-sock. Used only when you load a driver with mount after starting io-sock.
qnxdev=device: When Plug & Play is disabled, specifies the device instance to use. Use devinfo -v to determine the location value to use (e.g., qnxdev=pci0:0:25:0).

Description:

The devs-genet.so driver provides support for Raspberry Pi 4 Gigabit Ethernet devices.

This driver requires the mods-phy.so and mods-fdt.so drivers. For information on starting io-sock with a driver or loading a driver later using mount, see Starting io-sock and Driver Management in the High-Performance Networking Stack (io-sock) User's Guide.

Page updated: September 26, 2025