Knowledge Base

BSPs and drivers

Community resources

Product documentation

Questions?

Signal SA_RESTART

________________________________________________________________________

Applicable Environment

________________________________________________________________________

Topic: SA_RESTART
SDP: 6.3.2
Host/Target: N/A

________________________________________________________________________

SA_RESTART is not a signal but a signal action, as SA already hints at. This flag is used to make sure that a system call which has been interrupted by the original signal will not continue but be restarted. This behaviour is not implemented in QNX.

________________________________________________________________________

NOTE: This entry has been validated against the SDP version listed above. Use caution when considering this advice for any other SDP version. For supported releases, please reach out to QNX Technical Support if you have any questions/concerns.

________________________________________________________________________

Related Attachments

None Found

Please contact us with your questions or concerns.