Prerequisites

QNX Tool SuiteIntegrated Development Environment User's GuideDeveloperSetup

There are hardware and software requirements for the Lauterbach TRACE32 In-Circuit Debugger.

Before you can install, configure, and use the TRACE32-ICD, you must verify that you have the following hardware and software:
  • Hardware requirements:
    • Lauterbach PowerDebug or PowerTrace module
    • an appropriate JTAG debug cable for your specific target board
    • a USB or Ethernet cable to connect the debugger to your host
    • For the list of supported target architectures, see the Supported Processor Architectures heading on the left side of the Lauterbach homepage.
  • Software requirements:
    • Lauterbach TRACE32 Software Installation dated February 2016 or later
    • QNX Momentics IDE version 7.0 or higher
Page updated: