Knowledge Base

BSPs and drivers

Community resources

Product documentation

Questions?

Using RPC applications causes errors to be logged to slogger

________________________________________________________________________

Applicable Environment

________________________________________________________________________

Topic: Using RPC applications causes errors to be logged to slogger
SDP: 6.4.1
Target: Any supported target

________________________________________________________________________

Solution

________________________________________________________________________

When running RPC apps, you might see the following messages in the system logger:

cannot create socket for udp6
cannot create socket for tcp6

They refer to the fact that the RPC lib is attempting to communicate with the ipv6 stack, as well as ipv4. If the ipv6 stack (io-pkt-v6...) is not being used, the messages may be logged. They can safely be ignored if you are uninterested in ipv6 usage.

________________________________________________________________________

NOTE: This entry has been validated against the SDP version listed above. Use caution when considering this advice for any other SDP version. For supported releases, please reach out to QNX Technical Support if you have any questions/concerns.

________________________________________________________________________

Related Attachments

None Found

Please contact us with your questions or concerns.