Knowledge Base

BSPs and drivers

Community resources

Product documentation

Questions?

Setting RTS pin LOW/HIGH level of serial port using SW

________________________________________________________________________

Applicable Environment

________________________________________________________________________

Topic: Setting RTS pin LOW/HIGH level of serial port using SW
SDP: 4.25
Target: x86

________________________________________________________________________

Solution

________________________________________________________________________

qnx_ioctl()

Please check:

http://www.qnx.com/developers/qnx4/qnx4kb/solution.html?code=1200

and

Using the QNX4 qnx_ioctl() to raise and lower RTS and DTR.

http://connecttech.ca/KnowledgeDatabase/kdb103.htm

________________________________________________________________________

NOTE: This entry has been validated against the SDP version listed above. Use caution when considering this advice for any other SDP version. For supported releases, please reach out to QNX Technical Support if you have any questions/concerns.

________________________________________________________________________

Related Attachments

None Found

Please contact us with your questions or concerns.