There are hardware and software requirements for the Lauterbach TRACE32 In-Circuit Debugger.
Before you can install, configure, and use the TRACE32-ICD, you must verify that you have the following hardware and software:
- Hardware requirements:
- Lauterbach PowerDebug or PowerTrace module
- an appropriate JTAG debug cable for your specific target board
- a USB or Ethernet cable to connect the debugger to your host
- For the list of supported target architectures, see the Supported Processor Architectures heading on the left side of the
Lauterbach homepage.
- Software requirements:
- Lauterbach TRACE32 Software Installation dated February 2016 or later
- QNX Momentics IDE version 7.0 or higher