Home
Interfacing with your hardware
This chapter describes how to communicate with your given hardware.
Raspberry Pi hardware

Introduction
This introduction describes the basic requirements for using QNX SDP on the Raspberry Pi.
Quick start target image (QSTI)
This guide provides instructions on how to set up the quick start target image (QSTI) on a Raspberry Pi.
Custom target image (CTI)
This guide provides instructions on how to set up the custom target image (CTI) on a Raspberry Pi.
Interfacing with your hardware
This chapter describes how to communicate with your given hardware.
- Raspberry Pi hardware
The Linux Porting Guide
This guide provides comprehensive information on porting software from Linux to QNX.

Raspberry Pi hardware

The following sections describe how to interface with your hardware on a Raspberry Pi. This includes how to use GPIO modules.

Page updated: September 05, 2025