Continuing at a different address

Ordinarily, when you continue your program, you do so at the place where it stopped, with the continue command. You can instead continue at an address of your own choosing, with the following commands:

jump linespec
Resume execution at line linespec. Execution stops again immediately if there's a breakpoint there. See "Printing source lines" for a description of the different forms of linespec.

The jump command doesn't change the current stack frame, or the stack pointer, or the contents of any memory location or any register other than the program counter. If line linespec is in a different function from the one currently executing, the results may be bizarre if the two functions expect different patterns of arguments or of local variables. For this reason, the jump command requests confirmation if the specified line isn't in the function currently executing. However, even bizarre results are predictable if you're well acquainted with the machine-language code of your program.

jump *address
Resume execution at the instruction at address.

You can get much the same effect as the jump command by storing a new value in the register $pc. The difference is that this doesn't start your program running; it only changes the address of where it will run when you continue. For example:

set $pc = 0x485

makes the next continue command or stepping command execute at address 0x485, rather than at the address where your program stopped. See "Continuing and stepping."

The most common occasion to use the jump command is to back up—perhaps with more breakpoints set—over a portion of a program that has already executed, in order to examine its execution in more detail.