Serial communication

A serial connection allows the IDE to debug a program but not to use any profiling or analysis tools. You generally set up this connection type only when TCP/IP networking isn't available on the target.

First, you must physically connect the host and target machines through a serial port. Then, you must configure your target to use the serial link:
  1. If it's not already running, start the appropriate serial driver on the target.
    Typically, x86-based machines use the devc-ser8250 driver. ARM-based machines use a board-specific driver; for details on the starting the right driver, consult your BSP User's Guide. When the serial driver is running, you can run lsĀ /dev/ser* to see the path of the serial device.
  2. Start the pseudo-terminal communications manager, devc-pty, by entering the following command:
    # devc-pty &
  3. Determine the baud rate used by the serial port, using stty (this example assumes that you're using the first serial port):
    # stty </dev/ser1
    This command lists all parameters of the serial port. Look for the baud=baudrate entry; you'll need this information to properly configure both the target and host sides of the connection.
  4. Start the debugging agent, pdebug, while specifying the previously reported baud rate:
    # pdebug /dev/ser1,115200 &
    This example uses a baud rate of 115200 but the stty-reported rate on your system may differ.
You can now use the newly enabled serial link to debug a program on the target. The link transports data between the debugger on the host (GDB) and the supporting agent on the target (pdebug).