[Previous] [Contents] [Index] [Next]

Caution: This version of this document is no longer maintained. For the latest documentation, see http://www.qnx.com/developers/docs.

rtquery

Query routing daemons for their routing tables

Syntax:

rtquery [-1np] [-a secret] [-r addr] [-w timeout] host ...
        [-t op] host ...

Options:

-1
Query using RIP version 1 instead of RIP version 2.
-a passwd=XXX
-a md5_passwd=XXX|KeyID
Send the query with the specified RIPv2 cleartext or RIPv2 MD5 password.
-n
Display only the numeric network and host numbers instead of both the numeric and symbolic values.
-p
Use the poll command to request full routing information from gated. This is an undocumented extension RIP protocol supported only by gated.
-r addr
Ask about the route to destination addr.
-w timeout
Change the delay for an answer from each host. By default, each host has 15 seconds to respond.
-t op
Change the tracing settings. Requests from processes that aren't running with root privileges, or are on distant networks, are generally ignored by the daemon except for having a message logged in the system log.
on=tracefile
Turn on tracing to the tracefile. The tracefile was either specified when the daemon started, or is the same as a fixed name, typically /etc/routed.trace.
more
Increase the debugging level.
off
Turn off tracing.
dump
Dump the daemon's routing table to the current tracefile.

Description:

The rtquery utility is used to query a RIP network routing daemon, routed or gated, for its routing table by sending a request or poll command. The routing information in any routing response packets returned is displayed numerically and symbolically.

By default, it uses the request command. When -p is specified, rtquery uses the poll command, an undocumented extension to the RIP protocol supported by gated. When querying gated, the poll command is preferred over the request command because the response is not subject to split-horizon and/or Poisoned Reverse, and because some versions of gated do not answer the request command. Although routed doesn't answer the poll command, it recognizes requests coming from rtquery and answers them completely.

The utility is also used to turn tracing on or off in routed.

See also:

gated (an unsupported version is available on the QDN), /etc/gateways, routed

RFC 1058 Routing Information Protocol, RIPv1
RFC 1723 Routing Information Protocol, RIPv2


[Previous] [Contents] [Index] [Next]