Prerequisites

Before you begin to install, configure, and use the Lauterbach Trace32 In-Circuit Debugger, you'll need to verify that you have the following required hardware and software:

• Hardware requirements:
  • the Lauterbach Power Debug Module
  • the Lauterbach PODBUS Ethernet Controller
  • a JTAG debug cable — a debug cable that connects the Debug Module to the debug interface on your target and is suitable for your specific target architecture.
  • an Ethernet cable
  • a switch to your local network. For the list of supported target boards for Lauterbach, see the Lauterbach website at www.lauterbach.com.
• Software requirements:
  • the Lauterbach Trace32 Installation CD-ROM dated September 2006 or later
  • QNX Momentics IDE version 4.5 or higher
  Note: Since the Lauterbach Trace32 In-Circuit Debugger doesn't support Linux or Neutrino hosts, your host must run with Microsoft Windows.