Connect the Lauterbach Trace32 In-Circuit Debugger

Now, you want to physically connect the Debugger to the target hardware.

Figure 1. The Lauterbach architecture.
To connect the Lauterbach Trace32 In-Circuit Debugger to the target hardware:
  1. Locate your PODBUS Ethernet Controller and the Power Debug Interface hardware for the debugger.

    The Ethernet Controller should have a PODBUS OUT female port, and the Debug Interface should have a PODBUS In male port. Connect these two hardware components together through this port.

  2. Connect one end of your ethernet cable to the RJ45 jack of the PODBUS Ethernet Controller, and the other end to your local network's switch.
  3. Connect the parallel connector to the Debug Cable port of the Power Debug Interface. Connect the other end to the JTAG or COP port of your target hardware.
  4. Connect the power supply to the PODBUS Ethernet interface.
  5. Connect the 7.5V AC adapter to the power socket on the PODBUS Ethernet Controller and plug it in.