3. Networking with the QNX Neutrino RTOS

We've set up the virtual machine to use Network Address Translation (NAT), so that it's on the same IP network as your development host. To determine the target system's IP address, you can use the ifconfig command on the target's console:
Output from ifconfig

On your development host, use ping IP_address to check that it can reach your QNX Neutrino target on the network:
Running ping on the host


If your host machine uses a firewall, you might not be able to ping it from the target. On Windows, you might have to enable Allow incoming echo requests in the ICMP settings.

If you're using a Virtual Private Network (VPN), you might have to disconnect it.