devu-hcd-ohci.so

Driver for Open Host Controller Interface (OHCI) USB controllers

Note: You must be root to start this driver.

Syntax:

io-usb-otg -d ohci [option[,option...]] &

Runs on:

QNX Neutrino

Options:

ioport=addr
Register the base address of the USB controller. The default is to scan the PCI bus.
irq=num
The interrupt request number.
isoptd=num
Restrict the number of isoch frames each TD can transfer (default 8).
memory=name
Use the specified typed memory for DMA descriptors (endpoint descriptor, transfer descriptors, and so on). The default is /memory/below4G.
nosmm
Don't disable system management. The default is to disable it.
num_ed=num
The number of endpoint descriptors to preallocate. The number specified is added to the minimum number of endpoint descriptors needed to set up the USB chip.
num_td=num
The number of transfer descriptors to preallocate. The number specified is added to the minimum number of transfer descriptors needed to set up the USB chip.
pindex=num
The instance of the controller on the PCI bus to apply subsequent options to. The value starts from 0.
verbose=num
Set the verbosity level.

Description:

The devu-hcd-ohci.so server provides support for computers that have Open Host Controller Interface (OHCI) USB controllers. This server creates the /dev/usb/devu-hcd-ohci.so device.

Note: If you specify options, you need to include pindex options for all controllers you wish to use.

Examples:

Scan the PCI bus for all available controllers:

io-usb-otg -dohci

Attach to the 1st and 3rd controller instance and set the verbose option on the 1st, as follows:

io-usb-otg -dohci pindex=0,verbose=4,pindex=2 &