Debugging over a serial connection

GDB works over a serial connection, so you can debug a program on a target when a networking link isn't available on that device or when you're debugging networking.

Note: Debugging support is limited for serial connections, because you can start an application process with GDB attached but you can't attach GDB to a running process.
You must configure the target for serial communication before performing the IDE steps to select the target and launch the application with GDB attached.
To debug a program over a serial link:
  1. In the Launch Target dropdown, click New Launch Target to open the launch target wizard selector.
  2. Select QNX Serial Port Connection in the list of target types, then click Next to open the New QNX Serial Port Connection dialog.
  3. Fill in the serial port connection settings.
    You can provide any name for your new connection; this name will show up in the Launch Target dropdown. The Serial port field must name the host port used to talk over the physical link to the target. The Baud rate setting must match the value reported for the serial port on the target; this value is listed when you run stty on that target port when configuring serial communication. For the remaining fields, you can adjust their values but the default values shown are the more commonly used settings.
  4. Click Finish to create the target connection.
    An entry for the new target connection is added to and selected in the Launch Target dropdown. The IDE tries to connect to the target; if it succeeds, the dropdown entry shows a purple circle symbolizing a physical connector but with no red box (). If it fails, you'll see a red box with an X in the lower left corner of the icon ().
  5. In the Launch Configuration dropdown, select the project defining the application that you want to debug.
    In this release, you don't need to create a special launch configuration for serial debugging—you can use the default configuration for any project that supports debugging because this configuration works whether you're debugging over a TCP/IP or a serial link. Also, the Serial Port and Baud Rate properties no longer appear in the launch configuration (because they're set in the target connection).
  6. Click the Debug button (Icon: Debug button).

The IDE switches to the Debug perspective, which displays the source code being traced and other essential debugging information. If necessary, the IDE builds the application binary (with debugging information) and uploads it to the target. Then, it starts running the binary and GDB, which it attaches to the binary. If configured to do so in the Debug settings, the debugger stops on startup (by default, in the first line of main()).

For information on the debugging controls, see Debug perspective controls.

When a debugging session ends, pdebug always exits. When debugging over a serial link, you must either restart pdebug manually or use the target's reset command (if pdebug is launched during startup). The following shell script shows how to keep pdebug running so that it behaves like qconn:

while true 
  do 
     pidin | grep -q pdebug 
     if [ $? -ne 0 ] 
     then 
        echo Start pdebug 
        pdebug /dev/ser1,115200 
     fi 
     sleep 1 
  done