Driver for serial PCIs

Note: You must be root to start this driver.


devc-serpci [vid=vid,did=did[,pci=pci]] [options] &

Runs on:

QNX Neutrino




-b number
The initial baud rate (default 57600).
-C size
The size of the canonical buffer in bytes (default 256).
-c clock[/divisor]
Define a custom clock rate, in Hertz, and a divisor for the serial port. The default (-c 1843200/16) is suitable for compatible PC serial ports.
The PCI device ID, in hexadecimal (0xXXXX).
Set options to "raw" (default).
Start in edited mode (default raw). Software flow control is enabled by default.
Disable hardware flow control (default to hardware flow control enabled). Hardware flow control isn't supported in edited mode.
Enable hardware flow control (default). Hardware flow control isn't supported in edited mode.
-I number
The size of the raw input buffer in bytes (default 2048).
-O number
("Oh") The size of the interrupt output buffer in bytes (default 2048).
-o opt[,opt...]
Additional options, separated by commas. The options include:
  • nodaemon — don't call procmgr_daemon() to make the driver run in the background. Use this option if you need to know when the device terminates.
  • priority=prio — set the working priority of the internal pulse.
The PCI index, in decimal (XX).
Disable / enable software flow control. The default depends on the mode: in raw mode (-E, the default), it's disabled; in edited mode (-e), it's enabled.

The order in which you specify the -E or -e, and -S or -s options matters:

Options Mode Software flow control
-e Edited Enabled
-S -e Edited Enabled
-e -S Edited Disabled
-E Raw Disabled
-s -E Raw Disabled
-E -s Raw Enabled
-t number
Enable the receive FIFO and set its threshold to 1, 4, 8, or 14 characters. The default is 0 (trigger disabled).
-u number
Append number to the device name prefix (/dev/ser). The default is 1; additional devices are given increasing numbers.
Be verbose; additional v characters cause more verbosity.
The PCI vendor ID, in hexadecimal (0xXXXX).


The devc-serpci manager is a small serial device manager for the QNX Neutrino RTOS. This driver supports 16Cxxx compatible Serial PCI cards.

Note: The boards must use PCI I/O space for the registers, and the ports must be contiguous in memory.