Before you begin to install, configure, and use the Abatron BDI2000 Debugger, you need to verify that you have the following
required hardware and software:
Hardware requirements:
Abatron BDI2000 JTAG device
JTAG debug cable for your target architecture
Ethernet cable—a debug cable that connects the Abatron Debug Module to the debug interface on your
target and is suitable for your target architecture
Switch connected to your local network
For more information about the Abatron BDI2000 JTAG device, including the platforms it supports,
see the data sheet available from Ultimate Solutions, Inc.: