Zilog SCC serial communications manager (QNX Neutrino)
|You must be root to start this driver.|
devc-serzscc [[options] [port[^shift][+offset][,intr]]]... &
The options are position-dependent and affect the subsequent ports.
The order in which you specify the -E or -e, and -S or -s options matters:
|Options||Mode||Software flow control|
The default shift is 0.
The devc-serzscc manager is a small serial device manager for QNX Neutrino. It supports the Zilog SCC chip.
All devices are fully interrupt driven and by default support standard hardware flow control on input and output (RTS/CTS). This can be disabled by the -F option.
|Hardware flow control is not supported in edited mode.|
|If your application uses /dev/console,
you should create a link from it to one of
/dev/ser1, /dev/ser2, … by adding
a line like this to the buildfile used by mkifs:
[type=link] /dev/console = /dev/ser1
A read request by default returns when at least 1 character is available. To increase efficiency, you can control three parameters to control when a read is satisfied:
|If the Min value is greater than the size of the input buffer, the Min value is clipped to the size of the buffer. To avoid this, you can change the size of the input buffer with the -I option.|
These parameters are set using library routines (see tcgetattr(), tcsetattr(), readcond() and TimerTimeout() in the Library Reference).
The devc-serzscc manager supports both raw and edited modes, making it a real tty device.
The following fields and flags are supported in the termios structure:
|c_iflag||BRKINT ICRNL IGNBRK IXON|
|c_cflag||CLOCAL CSIZE CSTOPB PARENB PARODD|
|c_lflag||ECHO ECHOE ECHOK ECHONL ICANON IEXTEN ISIG NOFLSH|
Start devc-serzscc in edited mode, specifying the clock rate, baud rate, and inter-register access delay:
devc-serzscc -e -c4915200/16 -b9600 -D4000 0x81000000^3+4,0x8002 &