Before you begin to install, configure, and use the Abatron BDI2000 Debugger, you need to verify that you have the following
required hardware and software:
Hardware requirements:
Abatron BDI2000 JTAG device
an appropriate JTAG debug cable for your target architecture
an Ethernet cable — a debug cable that connects the Abatron Debug Module to the debug interface on your
target and is suitable for your target architecture
a switch connected to your local network
For more information about the Abatron BDI2000 JTAG device, including the platforms it supports,
see the data sheet available from Ultimate Solutions, Inc.: