After you connect to your target, the
Send File button becomes enabled (
) to indicate that you can transfer files from your host system to the target.
To transfer a file using the Terminal view:
-
Using either the Terminal view or another method (outside the IDE), configure
your target so that it's ready to receive an image. For details, see your
hardware documentation.
-
In the Terminal view, click the Send File button ( ).
-
In the Data Transmission dialog box, below the File to transfer box, and select file doing one of
the following actions:
-
Click Workspace, and in the File Selection dialog box, select a
file, and click OK.
-
Click Filesystem, and in the File Selection dialog box, select a
file from your host filesystem, and click Open.
-
In the Select transfer protocol area, select Transfer a file using the QNX sendnto
protocol or Transfer raw binary data over the connection.
Note: The QNX sendnto protocol sends a sequence of records (including the start record, data records, and a go record). Each record has a sequence number and a checksum. Your target must be running an IPL (or other software) that understands this protocol. For more information, see the
sendnto utility.
-
Click Finish.
The QNX System Builder transmits your file over the serial connection.
Note: You can click the
Cancel button to stop the file transfer:
