Configuring the Lauterbach Trace32 In-Circuit Debugger

1. Choose an IP address (from your local network DHCP server) for the JTAG debugger. Contact your system Administrator if you require assistance. Later, you'll also need to specify this IP address in the Lauterbach Trace32 In-Circuit Debugger configuration file.
2. Add the IP address obtained from step 1 to the Window's ARP cache. To perform this step, open a command prompt and type arp -s ip_addr mac_addr

   where:

   
   
   • ip_addr is the IP address from your local network DHCP server from step 1.
   • mac_addr is the address printed on a sticker on the back side of the PODBUS Ethernet Controller (e.g. 00-C0-8A-80-42-23).
3. Open the configuration file called config.t32 located in (by default) C:\T32\. If you specified another installation location, this location will be different.
4. Edit the line NODE=ip-addr and replace ip-addr with your IP address.
5. Add the following lines to the end of the config.t32 file:

   RCL=NETASSIST PACKLEN=1024 PORT=20006 

   Note: Ensure that you include a blank line before the first line, after the last line, and in between each of the lines.

Copyright | Community