Caution: This version of this document is no longer maintained. For the latest documentation, see


Get the number of clock cycles


#include <sys/neutrino.h>
#include <inttypes.h>

uint64_t ClockCycles( void );



Use the -l c option to qcc to link against this library. This library is usually included automatically.


The ClockCycles() kernel call returns the current value of a free-running 64-bit cycle counter. This is implemented on each processor as a high-performance mechanism for timing short intervals.

Several CPU architectures have an instruction that reads such a free-running counter (e.g. x86 has the RDTSC instruction). For processors that don't implement such an instruction in hardware (e.g. a 386), the kernel emulates one. This provides a lower time resolution than if the instruction is provided (838.095345 nanoseconds on an IBM PC-compatible system).

In all cases, the SYSPAGE_ENTRY(qtime)->cycles_per_sec field gives the number of ClockCycles() increments in one second.

Symmetric MultiProcessing systems

This function, depending on the CPU architecture, returns a value from a register that's unique to each CPU in an SMP system -- for instance, the TSC (Time Stamp Counter) on an x86. These registers aren't synchronized between the CPUs. So if you call ClockCycles(), and then the thread migrates to another CPU and you call ClockCycles() again, you can't subtract the two values to get a meaningful time duration.

If you wish to use ClockCycles() on an SMP machine, you must use the following call to "lock" the thread to a single CPU:

ThreadCtl(_NTO_TCTL_RUNMASK, ...)

Blocking states:

This call doesn't block.


Be careful about wrapping of the cycle counter. Use the following to calculate how many seconds before the cycle counter wraps:

(~(uint64_t)0) /SYSPAGE_ENTRY(qtime) -> cycles_per_sec




QNX Neutrino

Cancellation point No
Interrupt handler No
Signal handler Yes
Thread Yes

See also:

SYSPAGE_ENTRY(), ThreadCtl()