devn-el509.so

Driver for 3Com 509 ISA Ethernet adapters

Syntax:

io-net -d el509 [option[,option ...]] ...

Options:

Use commas (,) to separate the options (not spaces).

connector=type

Network cable connector type:

0

BNC

1

UTP

2

AUI

3

FIBER

The default is automatically detected on supported hardware.

ioport=port

The I/O port of the interface. The port parameter must be a hex address (e.g. 0x320). The default is automatically detected on supported hardware (but see caution below).

irq=req

The IRQ of the interface. The default is automatically detected on supported hardware (but see caution below).

mac=XXXXXXXXXXXX

MAC address of controller. The default is automatically detected on supported hardware.

mtu=X

Maximum transmission unit. The default is automatically detected on supported hardware.

nomulticast

Disables the driver from sending or receiving multicast packets. By default, multicast is enabled.

pcmcia

Flag to indicate a PCMCIA device to the driver.

promiscuous

Enable promiscuous mode. The default is off.

verbose
verbose=num

Be verbose. Specify num for more verbosity (num can be 1-4, the higher the number, the more detailed the output). The output goes to slogger, invoke sloginfo to view.

Description:

The devn-el509.so driver controls 3Com 509 ISA Ethernet adapters.

This driver cannot always detect the correct irq and ioport options, especially for ISA devices. To be sure, always specify irq and ioport when using this driver.

Examples:

Start io-net using the 509 ISA Ethernet adapter driver and the full TCP/IP stack:

io-net -d el509 ioport=0x320,irq=11 -p tcpip

Files:

/dev/io-net

The directory where, by default, drivers and protocol modules add entries. For more information, the documentation for io-net.

See also:

io-net

"Network drivers (devn-*)" and "Network protocol interfaces (npm-*)" in the Utilities Summary